Air King 6000 Instruction Manual download pdf (Page 3)

Â DO NOT USE OUTSIDE DEISNG INTENT OR WITH EQUIPMENT THAT IS NOT RECOMMENDED BY THE MANUFACTURER.

Â ALWAYS DISCONNECT THE AIR SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE OR ADJUSTMENT/FITTING OF NOSE EQUIPMENT

Â DO NOT OPERATE A TOOL THAT IS DIRECTED TOWARDS ANY PERSON(S) OR WITH THE MANDREL CATCHER OFF THE TOOL

Â ALL MODIFICATIONS CARRIED OUT ON THE TOOL WITHOUT EXPRESS WRITTEN CONSENT OF THE MANUFACTURER SHALL BE DONE

SO AT THE CUSTOMERS

’ SOLE RESPONSIBILITY

Â REFER TO THIS MANUAL BEFORE ATTEMPTING ANY MAINTENANCE OPERATION. DO NOT DISASSEMBLE THIS TOOL BEFORE

RFERING TO THIS MANUAL

Â AVOID EXCESSIVE CONTACT WITH HYDRAULIC OIL, AS SOON AS POSSIBLE WASH HANDS THOROUGHLY

Â DO NOT EXCEED 7 BAR / 100 PSI INLET PRESSURE, THE USE OF A PRESSURE REGULATOR IS HIGHLY RECOMMENDED

Â INSPECT THE TOOL USING PREVENTITIVE MAINTENANCE TECHNIQUES AT REUGULARLY SCHEDULED INTERVALS. INSPECT FOR

DAMAGE AND FUNCTION BY TRAINED COMPETANT PERSONEL

. REPLACE THE PNEUMATIC CYLINDER HOUSING OR HYDRAUILIC

CYLINDER HOUSING WHERNEVER THERE IS EVIDANEC OF IMPACT DAMAGE

, CHIPPING, OR CRACKING.

Â WEAR SAFETY GLASSES AND ADOPT FIRM FOOTING DURING OPERATION.

SPECIFICATIONS

The specifications and information contained in this manual are applicable only to the tool with which it was

supplied. Industrial Rivet & Fastener Co reserve the right to make any changes without notice as part of

Industrial Rivet & Fastener Co policy of continuous improvement.

SPECIFICATIONS FOR ZT-8000 RIVET TOOL

Air Pressure Min/Max

90 psi Max.

Bore Nom.

10 mm

Stroke Minimum

17 mm

Pull Force @5.5 bar/80psi

2,248 lbsF

Cycle Time Approximately

1.2 seconds

Noise Level Less than

125 dB(A)

Weight

4.3 lbs

Hydraulic Oil

Mobil DTFE 24

1 2 3 4 5 6 7 8 ... 13 14

No comments

Air King 6000 Instruction Manual Page 3