Air King LIN Series Troubleshooting Guide download pdf (Page 3)

www.airkinglimited.com

6728024M Rev. D 9-12 3 of 12

3 When there is access to the top of the unit, connect the ducting to the duct collar and

secure in place using tape to seal all joints (Figure 5).

4. When there is no access to the top of the hood, carefully pull down the metal duct

through the custom hood base hole. Slide this duct over the duct collar. Make sure the

adapter/damper assembly enters the ducting. Seal the connection with duct tape.

SECTION 5

Wiring

CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN

ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF

YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE

SERVICES OF A QUALIFIED ELECTRICIAN.

1. Remove the two wire compartment cover screws

to gain access into the wire compartment (Figure

6). Connect the white wire from the range hood to

the white wire from the supply, and the black wire

from the range hood to the black wire of the supply.

Connect the ground wire from the home (green or

bare) to the ground wire (green) from the hood. Use

approved methods for all connections (Figure 7).

2. Replace the wire compartment cover and tighten

screws. Make sure all wiring is securely contained

within the wire compartment. If the quick connect

wire connector was removed from the receptacle,

replace. The connector will only ﬁt one way into the

receptacle (Figure 6).

SECTION 6

Installing the Blower

1. Refer to the instructions included with the speciﬁc blower you have chosen for installation.

SECTION 7

Finishing the Installation

1. Install the proper lighting for your speciﬁc unit:

Halogen Lamps: Use PAR16 medium base 45W maximum Halogen lamps. Install

by inserting lamp into socket and turning clockwise until lamp is ﬁrmly seated. DO

NOT over tighten.

Wire Connector

Figure 6

Screws

Supply from house

Ground

(Green or Bare)

Neutral

(White)

Hot (Black)

Figure 7

Outlet Adapter

Hood

Screws

Flange

Figure 5

Ducting

2. If the included removable grease trough is not already installed within the hood, insert

into the rear inside channel of the hood. Make sure the taller side of the trough is facing

towards the back of the hood (Figure 8).

3. Install the bafﬂe ﬁlters and any spacers included with the unit by inserting the top of the ﬁlter

into the top channel of the hood, then slide the bottom of the ﬁlter into the bottom channel.

The ﬁlters have a top and a bottom. The bottom of the ﬁlter will have small drain holes.

These holes must be facing down towards the grease trough to be effective (Figure 9).

SECTION 8

Operation

Controls

Your Liner is equipped with two rotary switches with one controlling the lighting and the other

controlling the exhaust fan blower. The light switch has three positions, High, Low, and Off.

The fan switch has four positions, Off, High, Medium, and Low (Figure 10).

Thermostat

Your Liner is equipped with a thermostat that will automatically turn the Liner on when the

temperature exceeds a set point. Once the temperature drops, the thermostat will turn the Liner off.

CAUTION: THE LINER SHOULD ALWAYS BE TURNED ON OR OFF USING THE

CONTROL PANEL ANYTIME THE COOKING SURFACE IS BEING USED. DO NOT RELY ON THE

THERMOSTAT AS THE SOLE MEANS OF TURNING THE LINER ON OR OFF!

SECTION 9

Maintenance

CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE

SERVICING THE UNIT.

Grease Bafﬂes

Included with your range hood are stainless steel grease bafﬂes along with a grease trough

that should be washed at least once a month. The bafﬂes and trough are dishwasher safe and

should be washed in a mild soap or detergent. Reverse the instruction in SECTION 8 Finishing

the Installation, to remove bafﬂes and trough. If the grease bafﬂes become damaged, replace

with the appropriate Air King Grease Bafﬂes as described in the parts diagram.

Bottom

Channel

Figure 10

Light Switch

Blower Switch

Figure 8

Grease Trough

Channel

Figure 9

Top

Channel

1 2 3 4 5

Comments to this Manuals

No comments

Air King LIN Series Troubleshooting Guide Page 3

Comments to this Manuals