Air King EB Series Troubleshooting Guide Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
2. Turn switches to the “OFF” position and restore power. Test that the light and the fan are
operating properly.
3. If there is any vibration noise, check for the source and try to tighten fasteners.
SECTION 8
Operation
Controls
Your Range Hood is equipped with two rocker switches with one controlling the lighting and the
other controlling the exhaust fan. The light switch has three positions, Main Light, Night Light,
and OFF. The fan switch has three positions, High, Low, and OFF.
Fuse
Your range hood is equipped with a fuse located behind the control switches. To replace the
fuse, turn the fuse cap located next to the wire connector counter clockwise and pull out.
Replace with a Bussman MDA-3 or equivalent 125-Volt, 1.5 Amp Max. fuse. Reinstall the fuse
back into the hood.
www.airkinglimited.com
6728036 Rev. D 1-13 4 of 12
Troubleshooting Guide
Trouble Probable Cause Suggested Remedy
1. Hood does not operate when the switch is on. 1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker.
1b. Wiring is not connected properly. 1b. Turn off power to unit. Check that all wires are connected.
2. Hood is operating, but air moves slower than normal. 2. Obstruction in the exhaust ducting. 2. Check for any obstructions in the ducting including filter.
3. Hood is making a rattling noise. 3a. Filters are loose. 3a. Turn off power to unit. Check that all filter are securely in place.
3b. Duct connection is loose. 3b. Turn off power to unit. Check that duct connection is tight.
SECTION 9
Maintenance
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL
BEFORE SERVICING THE UNIT.
Filters
Grease Filter - Included with your range hood is an aluminum grease filter that should
be washed in hot water with detergent once a month. Reverse the instructions in the
“Finishing the Installation” section of the instructions to remove filter. If the grease filter
becomes damaged, replace with:
30" wide models: Air King model GF-09S grease filter
36" wide models: Air King model GF-10S grease filter
Charcoal Odor Filter - If you have installed an optional combination grease/charcoal
filter, it cannot be washed and must be discarded and replaced when it becomes
noticeably dirty, has stopped filtering the odors, or at least once per year. Replace with:
30" wide models: Air King model CF-09S combination odor/grease filter
36" wide models: Air King model CF-10S combination odor/grease filter
Cleaning
CAUTION: DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1. Clean your range hood with a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry before restoring power. NEVER IMMERSE ELECTRICAL PARTS IN
WATER.
2. The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over
time. The fan is permanently lubricated and does not require oiling.
Figure 9
Page view 3
1 2 3 4 5 6

Comments to this Manuals

No comments